Known Vulnerabilities
CVE-2024-39480
In the Linux kernel, the following vulnerability has been resolved: kdb: Fix buffer overflow during tab-complete Currently, when the user attempts symbol completion with the Tab key, kdb will use strncpy() to insert the completed symbol into the command buffer. Unfortunately it passes the size of the source buffer rather than the destination to strncpy() with predictably horrible results. Most obviously if the command buffer is already full but cp, the cursor position, is in the middle of the buffer, then we will write past the end of the supplied buffer. Fix this by replacing the dubious strncpy() calls with memmove()/memcpy() calls plus explicit boundary checks to make sure we have enough space before we start moving characters around.
CVE-2024-39479
In the Linux kernel, the following vulnerability has been resolved: drm/i915/hwmon: Get rid of devm When both hwmon and hwmon drvdata (on which hwmon depends) are device managed resources, the expectation, on device unbind, is that hwmon will be released before drvdata. However, in i915 there are two separate code paths, which both release either drvdata or hwmon and either can be released before the other. These code paths (for device unbind) are as follows (see also the bug referenced below): Call Trace: release_nodes+0x11/0x70 devres_release_group+0xb2/0x110 component_unbind_all+0x8d/0xa0 component_del+0xa5/0x140 intel_pxp_tee_component_fini+0x29/0x40 [i915] intel_pxp_fini+0x33/0x80 [i915] i915_driver_remove+0x4c/0x120 [i915] i915_pci_remove+0x19/0x30 [i915] pci_device_remove+0x32/0xa0 device_release_driver_internal+0x19c/0x200 unbind_store+0x9c/0xb0 and Call Trace: release_nodes+0x11/0x70 devres_release_all+0x8a/0xc0 device_unbind_cleanup+0x9/0x70 device_release_driver_internal+0x1c1/0x200 unbind_store+0x9c/0xb0 This means that in i915, if use devm, we cannot gurantee that hwmon will always be released before drvdata. Which means that we have a uaf if hwmon sysfs is accessed when drvdata has been released but hwmon hasn't. The only way out of this seems to be do get rid of devm_ and release/free everything explicitly during device unbind. v2: Change commit message and other minor code changes v3: Cleanup from i915_hwmon_register on error (Armin Wolf) v4: Eliminate potential static analyzer warning (Rodrigo) Eliminate fetch_and_zero (Jani) v5: Restore previous logic for ddat_gt->hwmon_dev error return (Andi)
CVE-2024-39462
In the Linux kernel, the following vulnerability has been resolved: clk: bcm: dvp: Assign ->num before accessing ->hws Commit f316cdff8d67 ("clk: Annotate struct clk_hw_onecell_data with __counted_by") annotated the hws member of 'struct clk_hw_onecell_data' with __counted_by, which informs the bounds sanitizer about the number of elements in hws, so that it can warn when hws is accessed out of bounds. As noted in that change, the __counted_by member must be initialized with the number of elements before the first array access happens, otherwise there will be a warning from each access prior to the initialization because the number of elements is zero. This occurs in clk_dvp_probe() due to ->num being assigned after ->hws has been accessed: UBSAN: array-index-out-of-bounds in drivers/clk/bcm/clk-bcm2711-dvp.c:59:2 index 0 is out of range for type 'struct clk_hw *[] __counted_by(num)' (aka 'struct clk_hw *[]') Move the ->num initialization to before the first access of ->hws, which clears up the warning.
CVE-2024-36971
In the Linux kernel, the following vulnerability has been resolved: net: fix __dst_negative_advice() race __dst_negative_advice() does not enforce proper RCU rules when sk->dst_cache must be cleared, leading to possible UAF. RCU rules are that we must first clear sk->sk_dst_cache, then call dst_release(old_dst). Note that sk_dst_reset(sk) is implementing this protocol correctly, while __dst_negative_advice() uses the wrong order. Given that ip6_negative_advice() has special logic against RTF_CACHE, this means each of the three ->negative_advice() existing methods must perform the sk_dst_reset() themselves. Note the check against NULL dst is centralized in __dst_negative_advice(), there is no need to duplicate it in various callbacks. Many thanks to Clement Lecigne for tracking this issue. This old bug became visible after the blamed commit, using UDP sockets.